Saturday, November 1, 2008

Plastic beads

I made shrink plastic beads when I saw this article on A Monthly Rubber Stamp Club back in 2003. I remember liking the outcome and wanted to give it a try again. I cut large triangles out of shrink plastic about 3" wide and 8-1/2" long. Roughed the surface with fine sand paper. I used chalk ink on the background and stamped flourishes with alcohol inks and a smaller flourish with black Stazon ink.
I placed the plastic onto a craft sheet with thick vellum on top and heated in the oven at 250 F. until they shrank and hardened. I wasn't worried that some of the pieces were misshapen, as they will be reheated and shaped into the bead shape. I colored the edges black with a black sharpie pen.
I ran a bobby pin with Versamark ink to facilitate its later removal (per the instructions in the above mentioned article). Clipped the bobby pin close to the edge of the wide end. I used a hemostat to hold the bobby pin while creating the bead. With a heat gun, re soften the plastic and wrap it around itself. Allow to cool.
When I made these beads 5 years ago, I had no trouble removing the bobby pins. This time, it was difficult to remove the bobby pin and caused some of the bead to break. I wonder if the type of bobby pin makes a difference? I decided to use the bobby pins as a design element. I think it has an Asian flair.

3 comments:

Anonymous said...

Beautiful effect.

xxxxxxxx

chrissy said...

These look GREAT!!! I just saw a similar article on making shrink plastic beads. I had my hubby make me the tool (dowel and bobby pin) and hopefully I can soon try this out myself.
Chrissy

Anonymous said...

An outstanding share! I've just forwarded this onto a co-worker who has been doing a little research on this. And he in fact bought me breakfast simply because I discovered it for him... lol. So let me reword this.... Thanks for the meal!! But yeah, thanx for spending time to talk about this subject here on your blog.
My blog post : pandora style bracelets